Recognize: 

recognize of installation

(1) The foundation-plate must be aircraft and stoutness and the base-plate must be screwed down and shock proof.

(2) The connecting shaft of primary mover, reducer and operation device need to be coaxial set up.

(3) The diameter tolerance zone of input and output shaft is H6, the holes of fittings( this kind of as couplings, belt-pully, sprocket wheel and so on) need to appropriately mate the shaft, which helps prevent bearing from breakage simply because of over-loose mate.

(4)  Motorists this kind of as sprocker wheel and gear should be equipped shut to bearings in order to decrease bending anxiety of hanging shaft.

(5) While assembling motor of WPD reducer, it is required that correct quantity of butter applies to the heat shaft input gap and keyway, keeping away from assembling as well tightly and rusting soon after making use of for a extended time.

(6) When buying or utilizing all kinds of WPD kind, if the motor weight is bigger than the widespread, supporting set is needed.

 notice of usage

(1) Before employing, you should verify meticulously regardless of whether the reducer model, distance, ratio, enter connecting technique , output shaft composition, input and output shaft route and revolving path accord with needed.

(2) In accordance to the prerequisite of deciding on lubricant oil in the solution manual. You should fill appropriate group and brand name lubricant. And then screw on the vent-plug, unlock the small cone-plug of vent-plug. Only soon after doing these, reducer is already for starting up up operating. The proper brand name and satisfactory lubricant oil is essential, replacing oil in time conforming to the request of product guide is also essential, specially soon after making use of 1st 100hours, it is essential refilling new oil.

(3) When irregular circumstances occur, remember to stop and check out reducer per remedies and motives for faults of reducer(allowable maximum oil temperature is ninety five, below this temperature limit, if oil temperature no more goes up, you should let reducer proceed running). 

Requirements:

 Input Power(KW)